Algitech Chemicals Udupi, Karnataka

Call Us
Contact Us

Floor Hardners & Epoxy Flooring

Dry Shake Floor Hardener Algihardfloor NM

Dry Shake Floor Hardener Algihardfloor NM

Approx. Rs 18 / Kilogram


ALGIHARD FLOOR NM

DRY SHAKE FLOOR HARDENER AND WATER PROOFER WHICH IS SUITABLE FOR BOTH DRY AND WET FLOORS.


Properties:

It has 3.5 times abrasion resistance of normal concrete. It produces highly abrasion resistant hard wearing surface, based on non metallic aggregates which do not corrode. Ideally suited for, dry docks, dry floors, heavy machine shops etc. Compressive 2 strength of ALGIHARD FLOOR NM is 600 Kg/cm .


Application Method:

Spread ALGIHARD FLOOR NM at the rate of 0.4 Kg/Sq. ft. over freshly laid concrete floor (2 to 3 hr after placing concrete) and finish the concrete surface with trowel or preferably with a power trowel. Spread another 0.2 Kg per Sq. Ft. just before the final set (3 to 4 Hours) and finish with trowel or power trowel.

 

 

Light Duty Epoxy Floor Coating

Light Duty Epoxy Floor Coating

Specifications: 

Epoxy Mortar System

Epoxy Mortar System

ALGIFLOOR EPX 320

Epoxy Mortar System For Heavy Duty Flooring (3 To 5mm Thickness).


It has excellent impact and abrasion resistance and can withstand very heavy loads. It is joint less and is non slip and hence suitable for industrial plants, processing areas, harbours, airports, workshop flooring subjected to heavy impact loading. Compressive strength after 2 days = 700 Kg/sq.m

Application method:


Coverage:

Algicoat EPX ZN

Algicoat EPX ZN

ALGICOAT EPX-Zn: Zinc rich primer for anti-corrosive coating on steel/MS structures

General Description :

Algicoat EPX-Zn is an epoxy coating with metallic zinc, which is especially formulated as a primer for preventing corrosion of steel structures.

Advantages:


Agicoat EPX-Zn can be used for the following Applications:

Method Of Usage:

Surface preparation:
The performance of Algicoat EPX-Zn is greatly reduced if the substrate is not cleaned thoroughly of rust, grease, oil etc. This can be done preferably with sand blasting or by cleaning with wire brush.


Application:

Mix base and curing agent in the proportion of 2:1 by volume in a plastic container. Allow it to remain for 5 minutes and apply at 50 microns dry film thickness. For better durability and performance, second coat of Algicoat EPX-Zn is recommended when applied on steel structures exposed to severe environment.

Health & Safety:
The Algicoat EPX-Zn is non-hazardous but poses a fire hazard. Do not smoke during application or store in sunlight or near hot surface. If it comes in accidental contact with the eyes, wash with plenty of water and take medical advice immediately. Do not store or mix near acids or alkalies as Zinc can react with these to cause hydrogen gas which is inflammable.
X
Provide Us More Details
Is this Requirement:

One Time Regular

How soon do you want this:

Immediate After 1 month

Purpose of Requirement:

Reselling End Use Raw Material

X

Looking for Floor Hardners & Epoxy Flooring ?

country-ico

We will contact you soon !

Prashant Lewis

(Managing Partner)

Algitech Chemicals

Brahmavara, Udupi, Karnataka, India

More Categories

View All Categories »
+91-8079466419
Contact Us